![]() sd 4:0:0:0: Write cache: enabled, read cache: enabled, doesn't support DPO or FUA sd 4:0:0:0: Power-on or device reset occurred usbcore: registered new interface driver uas usbcore: registered new interface driver usb-storage usb-storage 3-10:1.0: USB Mass Storage device detected usb 3-10: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 3-10: New USB device found, idVendor=2237, idProduct=4223, bcdDevice= 1.10 usb 3-10: new high-speed USB device number 2 using xhci_hcd Here are the lsusb and dmesg output in the second case: when the reader is visible from the computer: I suspect an hardware problem with my reader. ![]() Looking at dmesg I see some error message. ![]() However any attempt to access it close the connection from the computer side: the device is kind of "ejected". If I reboot the computer with the Reader plugged, I can see it with Thunar and Calibre detect the device. The reader is not mounted: it's not appearing in Thunar, Calibre can't see it, no mounting point corresponding appear in mount output. However in most of the case nothing happen. dmesg show a connection on a USB port with no error message. From the computer side now the lsusb command see perfectly the Reader, its number. When I plug the reader via the USB cable, the reader ask to be connected (or not) with the computer.I accept and then the reader show the message "you are connected blablabla". In fact both OS are up-to-date (Kobo OS on the reader and Arch on the computer). I suspect an hardware problem on the reader. ![]() My problem is to connect the reader to my computer. Well for reading book and so it's works as expected. ![]() I have a Kobo EPub reader that works perfectly. ![]()
0 Comments
Leave a Reply. |